A3Com-Mip-r1-MIB.mib object view, vendor 3Com
Introduction
Most network devices and programs ship with so-called MIB files to describe the parameters and meanings (i.e.: friendly names) which are available for monitoring via SNMP.
ActiveXperts Network Monitor 2024 can import vendor-specific MIB files, so it can be used to monitor specific OID's (Object Identifiers).
This way, you can monitor your devices, computers, etc. by selecting your relevant OID's by name.
ActiveXperts Network Monitor 2024 can import MIB file A3Com-Mip-r1-MIB and use it to monitor vendor specific OID's.
A3Com-Mip-r1-MIB file content
Object view of A3Com-Mip-r1-MIB:
| Scalar Object |
| a3ComMipControl |
.1.3.6.1.4.1.43.2.27.1.1 |
|
If this object is set to enabled(1), then multicast IP routing is in
service. If it is set to disabled(2), then multicast IP routing is
turned off.
|
| a3ComMipPortEntry |
.1.3.6.1.4.1.43.2.27.2.1.1 |
|
Each entry contains information for a spcified port or tunnel.
|
| a3ComMipLocalGroupEntry |
.1.3.6.1.4.1.43.2.27.2.2.1 |
|
Each entry contains a group membership information associated with
a specific port.
|
| a3ComMipSmdsGroupEntry |
.1.3.6.1.4.1.43.2.27.2.3.1 |
|
Each entry contains an IP network address to SMDS group address mapping.
|
| Tabular Object |
| a3ComMipPortIndex |
.1.3.6.1.4.1.43.2.27.2.1.1.1 |
|
The port number or tunnel ID of which this entry applies. The
tunnel ID starts with 1025 and end with 1056, i.e. total tunnel
number is limited to 32.
|
| a3ComMipPortQueryInterval |
.1.3.6.1.4.1.43.2.27.2.1.1.2 |
|
This object specifies the time interval in seconds that a Host
Query message is sent to the attached subnet to request for the
local group membership. It also derives the Membership Expiration
time which is set to two times value of this object plus 20
seconds. This object cannot be applied on tunnel port.
|
| a3ComMipPortThreshold |
.1.3.6.1.4.1.43.2.27.2.1.1.3 |
|
This object specifies the minimum IP TTL required for a multicast
datagram to be forwarded to the given port or tunnel.
|
| a3ComMipPortQuerier |
.1.3.6.1.4.1.43.2.27.2.1.1.4 |
|
This object specifies if the system is responsible for sending out
Host Query messages on this port. If the value is yes(1) then the
system is the designated router on the subnet this port connects to
and the system is sending out Host Query messages periodically on
that port. This object must be set to value no(2) for tunnel port.
|
| a3ComMipPortPaceMode |
.1.3.6.1.4.1.43.2.27.2.1.1.5 |
|
This object is used to control PACE mode. If set to enabled(1),
the multicast packets will be sent out with the Universal/Local bit
set, or Priority MAC. If set to disabled(2) the Universal/Local bit
is clear, or Interactive MAC.
|
| a3ComMipLocalGroupPort |
.1.3.6.1.4.1.43.2.27.2.2.1.1 |
|
This object specifies the port number to which this entry applies.
|
| a3ComMipLocalGroupIpAddr |
.1.3.6.1.4.1.43.2.27.2.2.1.2 |
|
This object specifies group's address presents on the specified
port. If the port is configured as a tunnel, there will be no group
address associated with it.
|
| a3ComMipLocalGroupType |
.1.3.6.1.4.1.43.2.27.2.2.1.3 |
|
This object specifies the type of local group. This object can only
be set to 'static' by SET command, and if the local group is learned
from IGMP, it is set to 'igmp'.
|
| a3ComMipLocalGroupStatus |
.1.3.6.1.4.1.43.2.27.2.2.1.4 |
|
This object is used to add and delete entries in this table. See
the definition of RowStatus for detail.
|
| a3ComMipSmdsGroupIpAddr |
.1.3.6.1.4.1.43.2.27.2.3.1.1 |
|
This is an IP network address for which there is a corresponding
SMDS group address.
|
| a3ComMipSmdsGroupMediaAddr |
.1.3.6.1.4.1.43.2.27.2.3.1.2 |
|
This is the SMDS group address that corresponds to the IP network
address identified by a3ComMipSmdsGroupIpAddr.
|
| a3ComMipSmdsGroupStatus |
.1.3.6.1.4.1.43.2.27.2.3.1.3 |
|
This object is used to add and delete entries in this table. See
the definition of RowStatus for detail.
|
| Table |
| a3ComMipPortTable |
.1.3.6.1.4.1.43.2.27.2.1 |
|
This table contains entries of parameters associated with every port
or tunnel.
|
| a3ComMipLocalGroupTable |
.1.3.6.1.4.1.43.2.27.2.2 |
|
This table contains group membership information of each attached
subnet.
|
| a3ComMipSmdsGroupTable |
.1.3.6.1.4.1.43.2.27.2.3 |
|
This table contains a set of IP network address and SMDS group address
mapping.
|
| Object Identifier |
| a3Com |
.1.3.6.1.4.1.43 |
| brouterMIB |
.1.3.6.1.4.1.43.2 |
| a3ComMIP |
.1.3.6.1.4.1.43.2.27 |
| a3ComMipSConfig |
.1.3.6.1.4.1.43.2.27.1 |
| a3ComMipCConfig |
.1.3.6.1.4.1.43.2.27.2 |
| a3ComMipData |
.1.3.6.1.4.1.43.2.27.3 |
