| srcpVersion |
.1.3.6.1.4.1.351.150.11.1.1.1 |
|
The name of the SRCP protocol version for
exmaple SRCP 1.0.2. If MGMIB is supported,
this name corresponds to mgProtocolName
(defined in CISCO-WAN-MG-MIB MIB) in an
entry to mgSupportedProtocolTable.
|
| srcpPortNumber |
.1.3.6.1.4.1.351.150.11.1.1.2 |
|
This object is used to configure the UDP port used
for SRCP on the system (local UDP port). It is
configurable only if the system is in a locked or
disabled state (i.e If MGMIB Is supported,
mgAdministrativeState(defined in CISCO-WAN-MG-MIB MIB)
should be 'locked' before the UDP port can be configured).
|
| srcpPeerEntry |
.1.3.6.1.4.1.351.150.11.1.1.3.1 |
|
Represents an individual table entry in srcpPeerTable.
Each row corresponds to an SRCP peer and is identified
by its domain name (srcpPeerName).
Entries in this table are implicitly created by the agent.
If the agent supports MGMIB, this occurs as follows:
An entry shall be created when an entry is created in the
mgcRedundancyGrpProtocolTable(defined in
CISCO-WAN-MGC-REDUN-MIB MIB) and when
mgProtocolNumber (defined in CISCO-WAN-MG-MIB MIB)
refers to SRCP as supported protocol. An entry will
be made for all MGC(Media Gateway Controller) in
that MGC Redundancy Group. Accordingly, an entry
shall be deleted if the corresponding entry in
the mgcRedundancyGrpProtocolTable is deleted.
If the agent does not support MGMIB, entry creation
might occur when the first SRCP communication with
an IP address/domain name occurs.
if MGC Redundacy feature is supported the following objects:
srcpPeerHeartbeatInterval, srcpPeerTimeSinceHeartbeat
rcpPeerMaxPduSize are not meaningful here. These objects
are defined per MGC Redundancy Group rather than per MGC.
|
| srcpPeerGrpParamEntry |
.1.3.6.1.4.1.351.150.11.1.1.4.1 |
|
Represents an individual table entry in the
srcpPeerGrpParamTable. Each row corresponds to
an MGC Redundancy Group and is identified by the
MGC Redundancy Group Number.
Entries are implicitly created when the SRCP protocol
is added for an MGC Redundancy Group. The entry will
be removed if the SRCP protocol is removed for an MGC
Redundancy Group.
|
| srcpRequestTimeOut |
.1.3.6.1.4.1.351.150.11.1.3.1 |
|
This object specifies the minimum timeout value.
This value along with srcpRequestMaxTimeout and
srcpRequestRetries is used to determine the exponential
retry interval for retransmitting unacknowledged SRCP
messages.
It is the responsibility of the requesting entity to
provide suitable timeouts for all outstanding commands,
and to retry commands when timeouts exceeded.
The default value of this object is 500 milliseconds.
When the value of this object changes srcpAdminObjects
group changed trap will be sent as specify by
vismConfigChangeTypeBitMap in CISCO-VISM-MODULE-MIB.
|
| srcpRequestRetries |
.1.3.6.1.4.1.351.150.11.1.3.2 |
|
This object specifies the number of retries for a SRCP
request that exceeds timeout. It is the responsibility
of the requesting entity to provide suitable timeouts for
all outstanding commands, and to retry when times out.
The default value of this object is 3.
When the value of this object changes srcpAdminObjects
group changed trap will be sent as specify by
vismConfigChangeTypeBitMap in CISCO-VISM-MODULE-MIB.
|
| srcpRequestMaxTimeout |
.1.3.6.1.4.1.351.150.11.1.3.3 |
|
This object specifies the maximum timeout value.
This timer value is used along with srcpRequestTimeOut and
srcpRequestRetries to determine the exponential retry
interval for retransmitting unacknowledged SRCP messages.
The value of this timer has to be greater than or equal to
srcpRequestTimeOut.
The default value of this object is 500 milliseconds.
When the value of this object changes srcpAdminObjects
group changed trap will be sent as specify by
vismConfigChangeTypeBitMap in CISCO-VISM-MODULE-MIB.
|
| srcpPeerStatsEntry |
.1.3.6.1.4.1.351.150.11.1.2.1.1 |
|
The row of the srcpPeerStatsTable contains information about
SRCP message statistics per IP address of the MGC.
An entry is implicitly created and deleted by the agent.
There can be two cases:
1. Case of Internal address resolution : In this case IP
addresses of all SRCP peers are resolved internally.
If the agent supports the MGMIB, the following
referential integrity rules apply:
When an entry is added to mgcResolutionTable defined in
CISCO-WAN-MG-MIB with a specific IP address, an entry
is created in this srcpPeerStatsTable for that IP address.
When an entry is deleted from mgcResolutionTable,
the row with the corresponding IP address in this table
will be deleted.
2. Case of External address resolution : If there is at
least one Call agent whose IP address is resolved
externally, an entry is created whenever SRCP
communication occurs with a new IP address. Table
entries are never deleted, but must be
nonpersistent in agent implementations, i.e. must be
purged in case of a system shutdown/restart.
|
| srcpPeerId |
.1.3.6.1.4.1.351.150.11.1.1.3.1.1 |
|
This object identifies the SRCP peer and serves
as index to this table. If MGMIB is supported,
this is the same as the mgcNumber(defined
in CISCO-WAN-MG-MIB MIB) from the mgcTable.
|
| srcpPeerName |
.1.3.6.1.4.1.351.150.11.1.1.3.1.2 |
|
This object identifies the name of the SRCP peer.
If MGMIB is supported, this is the same as the
mgcName from the mgcTable.
|
| srcpPeerPortNumber |
.1.3.6.1.4.1.351.150.11.1.1.3.1.3 |
|
This object is used to configure the UDP port of
the SRCP peer.
|
| srcpPeerHeartbeatInterval |
.1.3.6.1.4.1.351.150.11.1.1.3.1.4 |
|
This object is used to configure the length of the
heartbeat interval, in milliseconds. The heartbeat
interval indicate when the GW(Gateway) is expected to
receive a heartbeat from a specific peer or MGC group.
If value is 0, heartbeat for this peer is not
monitored. The heartbeat interval less than 100 is
not allowed (except 0).
If MGC Redundancy is supported, this object is not
effective. Instead, the user should use
srcpPeerGrpHeartbeatInterval.
|
| srcpPeerTimeSinceHeartbeat |
.1.3.6.1.4.1.351.150.11.1.1.3.1.5 |
|
The time since the last heartbeat was received, in
milliseconds. This represents the difference between
the current time and the last time an SRCP command was
received.
A value of 0 shall be returned if the heartbeat is not
monitored. Even if the heartbeat is monitored, a value
of 0 shall be returned if any of the following is true:
i) The system is locked or disabled (as indicated by
mgAdministrativeState).
ii) The srcpPeer is unassociated as indicated by
mgcAssociationState(defined in CISCO-WAN-MG-MIB MIB).
If MGC Redundancy is supported, this object is not
effective. Instead, the user should use
srcpPeerGrpTimeSinceHeartbeat.
|
| srcpPeerMaxPduSize |
.1.3.6.1.4.1.351.150.11.1.1.3.1.6 |
|
This object is used to configure the maximum UDP
PDU(Protocol Data Unit) size, in octets, that may
be used for SRCP communications with the peer.
This value may not be configurable for all agents.
If MGC Redundancy is supported, this object is not
effective. Instead, the user should use
srcpPeerGrpMaxPduSize.
|
| srcpPeerGrpHeartbeatInterval |
.1.3.6.1.4.1.351.150.11.1.1.4.1.1 |
|
This object is used to configure the length of the
heartbeat interval, in milliseconds. If 0, heartbeat
for this peer Group is not monitored. The heartbeat
interval less than 100 is not allowed (except 0).
|
| srcpPeerGrpTimeSinceHeartbeat |
.1.3.6.1.4.1.351.150.11.1.1.4.1.2 |
|
The time since the last heartbeat was received,
in milliseconds. This represents the difference
between the current time and the last time an SRCP
command was received.
A value of 0 shall be returned if the heartbeat is not
monitored. Even if the heartbeat is monitored, a value
of 0 shall be returned if any of the following is true:
i) The system is locked or disabled (as indicated by
mgAdministrativeState).
ii) The stateChangeNtfy flag is disabled for the srcpPeer
Group (as indicated by mgcRedundancyGrpStateChangeNtfy
of CISCO-WAN-MGC-REDUN-MIB).
|
| srcpPeerGrpMaxPduSize |
.1.3.6.1.4.1.351.150.11.1.1.4.1.3 |
|
This object is used to configure the maximum UDP PDU size,
in octets, that may be used for SRCP communications with
the peer. This value may not be configurable for all agents.
|
| srcpStatsPeerIpAddress |
.1.3.6.1.4.1.351.150.11.1.2.1.1.1 |
|
This object specifies the IP address of the
SRCP peer and serves as index to the table.
|
| srcpStatsPeerName |
.1.3.6.1.4.1.351.150.11.1.2.1.1.2 |
|
Denotes the name of the SRCP peer. This is the
same as the mgcName from the mgcTable. It is provided
here as a read-only parameter as a convinience feature.
|
| packetsDiscardedCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.3 |
|
The number of packets that were received and discarded.
The packets may get discarded because of indecipherable
PDUs like bad protocol version, bad command verb etc, or
because of unknown transaction IDs (in case of SRCP clients).
|
| augwCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.4 |
|
The total number of AUGW(Audit Gateway) commands received
from the peer on this IP address.
|
| aulnCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.5 |
|
The total number of AULN(Audit Line) commands received from
or sent to the peer on this IP address.
|
| rqntCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.6 |
|
The total number of RQNT(Notification Request) commands
received from or sent to the peer on this IP address.
|
| ntfyCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.7 |
|
The total number of NTFY(Notify) commands received from
or sent to the peer on this IP address.
|
| augwFailCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.8 |
|
For MG : The total number of AUGW commands
received that were responded to with a failure
return code.
For MGC : The total number of AUGW commands sent which
were timed out without a response or for which a response
with failure return code was received.
|
| aulnFailCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.9 |
|
Media gateway : The total number of AULN commands
received that were responded to with a failure
return code.
Media gateway controller : The total number of AULN
commands sent which were timed out without a response or
For which a response with failure return code
was received.
|
| rqntFailCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.10 |
|
Media gateway : The total number of RQNT commands
received that were responded to with a failure return
code.
Media gateway controller : The total number of RQNT
commands sent which were timed out without a response
or for which a response with failure return code was
received.
|
| ntfyFailCnts |
.1.3.6.1.4.1.351.150.11.1.2.1.1.11 |
|
Media gateway : The total number of NTFY commands sent
which were timed out without a response or for which a
response with failure return code was received.
Media gateway controller: The total number of NTFY commands
received that were responded to with a failure return code.
|
